Essilor Neksia, Руководство пользователя

Страница: 62 / 84

4. C
HANGING OR CLEANING THE EDGER TOOLS
This menu enables you to perform several operations on the tools of the edger:
• Drill bit: clean or replace with a different diameter or new bit
• Chamfering wheel: replace with a new wheel
• Grooving wheel: replace with a new wheel
Wear indicators
An indicator in the information bar shows the level of wear on the drill bit: 1.0 mm or 0.8 mm wear on
the drill bit
The colour of the indicator informs you of the level of wear of the tool:
• Green for a new tool
• Flashing red for a tool which needs replacing: press on the indicator for direct access to the
tool-change menu.
• Always use the tools recommended by Essilor.
• Do not use the edger if one of the tools is missing. Never remove a used or broken tool if you
cannot replace it.
• All tools used on the module must be clean and dry to prevent water from seeping into the
mechanisms.
• The use of broken tools may cause lens breakage or errors with respect to lens shape or drill-
hole diameter: change the tools as soon as they are worn (check the indicators and statistics of
your digital system).
• Incorrect positioning of the tools may cause breakage or errors with respect to lens shape or
drill-hole diameter: insert the tools fully.
a. Changing or cleaning the drill bit
The wear indicator informs you of the need to change the 0.8 mm drill bit after 250 holes and the 1.0 mm bit
after 500 holes.
Have the following to hand:
• Open-ended spanner
• Drill bit changeover tool
• The drill bit to be replaced
From the work screen of your edger, select > > to change or clean the drill bit.
You can access the tool-change menu by pressing on the work screen.
Neksia > v1.0 - 02.14
62
U
SER
M
ANUAL
> IV. M
AINTENANCE
&
SERVICING