Essilor Neksia, Руководство пользователя

Страница: 52 / 84

◦ Press to move the polished bevel towards the front surface of the lens.
◦ Press to move the polished bevel towards the rear surface of the lens.
3. Default groove position
◦ Press to move the groove towards the front surface of the lens.
◦ Press to move the groove towards the rear surface of the lens.
Once the change has been made, press to return to the work screen.
c. Adjusting the diameter of drill-holes
After drilling a lens, if the diameter of the holes always seems too small or too big, you can adjust it
according to the diameter of the drill bit used and the lens material.
To access that menu from your edger work screen, select > > .
The following screen is displayed:
1. Drill bit diameters
0.8 mm or 1.0 mm.
2. Lens materials
◦ Plastic
◦ Polycarbonate
◦ MHI
◦ Trivex TM
◦ Tribrid TM
3. Increasing or reducing the default drill-hole diameter
a. Press the value to be modified.
> The numeric keypad is displayed.
b. Enter the new value.
◦ Negative value: the hole will be smaller
◦ Positive value: the hole will be larger
Neksia > v1.0 - 02.14
52
U
SER
M
ANUAL
> III. C
ONFIGURING THE EDGER