Essilor Neksia, Руководство пользователя

Страница: 18 / 84

◦ Thin chamfer
◦ Thick chamfer
◦ No chamfering
11. Manual lens clamping
Press and hold to close the lens clamp shafts manually.
12. Start the edging cycle
The door closing and lens clamping are automatic.
Always browse from left to right: depending on your selection, certain menus will be available while
others will not.
Your habits taken into account
The edger memorises your working habits: as time goes by, the buttons of the functions you use most
often will be displayed by default.
b. Calling a shape
There are 3 ways of calling the shape you want to edge:
• Calling the current job:
> Press to display the shape being processed on the tracer.
• Calling the number of a shape saved on the tracer:
> Press for a few seconds on to open the numeric keypad.
> You can then call a shape via the ID allocated to it.
• Job call via a barcode:
> Scan the barcode using the barcode reader (optional).
Always block your two lenses before proceeding with the edging. If a job in the course of modification on the
tracer (display of the symbol beside the reference) is called on the edger, a warning message is
displayed.
> Press to continue and display the job on the edger. The modifications underway are then ignored.
> Press to prevent the display of the job and finish the modifications underway on the tracer.
A reminder of the type of posiblock required is displayed on the shape. It is crucial to use the proper
accessory to edge the lens. Otherwise, an error message is displayed at the start of the cycle.
Neksia > v1.0 - 02.14
18
U
SER
M
ANUAL
> II. E
DGING A LENS