Esko Kongsberg XE10, Руководство пользователя

Страница: 93 / 133

15
Kongsberg XE
1. Select the Tool to be adjusted.
2. Press the Adjust Active Tool button to enter the wizard selection dialog.
3. Select Rotation adjustment.
4. Follow the instructions given by the wizard, step by step.
5. Repeat the procedure for all Tools mounted.
Manual Adjustment
1. Place an appropriate test material on the table, and switch Vacuum On .
2. From Tool Configuration dialog, select one Tool .
3. Press Adjust Active Tool to enter the Wizard Selection Dialog .
4. Select Manual Adjustment of Center Offset and Angle .
5. Enter value for the Angular Offset and select Activate .
6. Note that the Tool will rotate as the new value is activated.
7. Press Tool Override Down , and Jog approximate 10 cm to make a test cut.
8. Press Tool Override Down once more to lift the Tool again.
9. Press Tool Override Down once more to lower the Tool again.
10. Note how the knife enters into the material.
11. Press Tool Override Down once more to lift the Tool again.
12. If knife enters exact into the cut, the angle is correct; select Finish to exit.
13. If seen in the cutting direction, the knife enters to the left of the cut, the Angular Offset
Value should be decreased. Repeat from point 5.
14. If seen in the cutting direction, the knife enters to the right of the cut, the Angular Offset
Value should be increased. Repeat from point 5.
15.7 Center Offset Adjustment
The adjustment can be done using the Adjustment Wizards , or by a Manual Adjustment
procedure:
Adjustment using Wizards
93