Esko Kongsberg XE10, Руководство пользователя

Страница: 110 / 133

16
Kongsberg XE
For fine adjustment, proceed as follows:
1. Use a sheet of carton with known thickness
t.
2. On the cutting table, place the carton on
top of a sheet of paper as illustrated at left.
3. Prepare a job setup file with P1 = VariCut
and specify a cutting depth = t.
4. Execute the IAT-file 'square01.acm' and
check the cutting depth.
5. Adjust the "Align knife tip with foot" value
and repeat the procedure until the knife
cut is exactly through the carton without
cutting into the paper beneath.
6. Now the VariCut cutting depth is properly
adjusted.
Adjust foot pressure
The downwards foot pressure has to be
adjusted depending upon the actual material.
The pressure F is adjusted with the knob A.
The illustration shows how to adjust to obtain
a Low or High pressure.
If you are cutting in a hard material, the
pressure has to be increased in order to keep
the knife down.
If you are cutting in a soft material, the
pressure should be reduced in order not to
scratch the surface of the material.
110