Esko Kongsberg XE10, Руководство пользователя

Страница: 80 / 133

13
Kongsberg XE
Across the flute
Entering a positive value specifies a depth measured from the top of the material, but:
• For knife cutting, a value = 0 specifies through-cut.
• For pen, crease, drill and router, a value = 0 specifies the top of the material.
If you specify a T+/- value, the value specifies a distance from the cutting underlay.
T0 specifies cutting or milling through the material down to the cutting underlay.
A positive T-value will increase the cutting / creasing depth.
Note: The T - function is available only when mm/inch is selected as depth unit.
X/Y speed
The speed can be reduced to an absolute value or to a percentage (%) of
maximum speed, depending upon the 'Speed unit' setting.
This value affects tool down movements only.
X/Y acceleration
The acceleration can be reduced to a percentage (%) of the maximum
acceleration.
This value affects tool down movements only.
Z-axis Speed
The speed can be reduced to an absolute value or to a percentage (%) of
maximum speed, depending upon the 'Speed unit' setting.
RPM
Specify RPM for the Milling tool.
Laser pointer = Ignore
This function specifies the behavior of lines with tool type 'No-tool':
Function disabled - the line is executed using laser pointer (verify mode).
Function enabled - the line is ignored during program execution (ignore mode).
Knife before crease
Use this function to force all knife movement to be executed before the crease movements.
Normally this option should be turned off.
It is recommended to use this option if the crease lines are done with a V-Notch tool.
80