All rights reserved. Reproduction as well as electronic duplication of this guide, complete or in part, requires the written consent of ESERA-
Automation or E-Service GmbH. Errors and technical modification subject to change.
©
ESERA-Automation, E-Service GmbH 2019
www.esera.de
Programming Manual Controller-Gateway-Station V1.0 R1.1
Page 68 of 77
22.4.
Set One Wire Device Command
Befehle die die 1-Wire Bausteine im Einzelnen betreffen
1
2
3
4
5
Description
SET
OWD FORMAT
0-2
Defines the decimal places for temperature
sensors. Range: 0-2 digits
Default: Integer value for 2 digits
DS2408INV
0 or 1
Inverts the data of DS2408 devices (8-fold
I/O). Default = 1
Optimized for 8-fold switching module
DS2450ADC
0 or 1
Setting of the data output for DS2450 devices
is output
0=16Bit Integer Values
1=Analog voltage in mV with two decimal
places, e.g. 2560 correspond to 2560mV
(2.56V)
ART
number
(1-30)
ID
Assigns the ESERA-Automation article number
to modules for correspondingly adapted
outputs, e.g. for humidity sensors
OUTH
number
(OWD 1-30)
value
Writes a value for a digital output module, e.g.
switching module, analog output, etc. All
outputs are switched at once.
Example 255=all outputs active
Command for DS2405, DS2413, DS2408
If the written value is too large for the device,
an error message will be issued.
OUT
No.
(OWD 1-
30)
output
value
Set a single output of a digital output module.
Command for DS2405, DS2413, DS2408
OUTA
number
(OWD 1-30)
value
mV
Writes an analog output 0 - 10V for
Art. No. 11208
Value = Output value in mV (10V = 1000)
OUTAMA
number
(OWD 1-30)
value
mA
Writes an analog output 0 - 20mA for Art. No.
11219
Value = Output value in mV (20mA = 2000)
OUTPWM
number
(OWD 1-30)
value
%
Writes a PWM output 0 - 100% for Art. No.
11225
Value = initial value in %
DIM
No.
(OWD 1-
30)
number
value
Dimmer value for one output of the 1-Wire
dimmers
Command for DS2408 module interface
SHT
OWD
number
Control command for shutter module Art. No.
11209
Value: 1=Down, 2=Up, 3=Stop
SHT
4*
OWD
output
value
Control command for 4-fold shutter module
Art. No. 11209
Output: 1-4,
Value: 1=Down, 2=Up, 3=Stop
NAME
number
(1-30)
text
Text field for OWD devices with up to 20
characters. Letters, numbers and special
characters are allowed.
No blanks allowed.
CNAME
number
(1-30)
Deletes an OWD text
ID
serial-
number
1-Wire
Device
Manual setting of a 1-Wire serial number (16
digits) even if the sensor is not connected. The
entered serial number is double-checked for
plausibility. If an error occurs, an error
message will be output. For details refer to
"Error Code" point 21.
A serial number beginning or ending with the
family code can be entered.
