Ericsson SmartEdge 600, Руководство по оборудованию

Страница: 44 / 174

SmartEdge 600 Router Hardware Guide
GBIC transceivers are supported only on ports the first and second versions
of the Gigabit Ethernet line cards. SFP transceivers are supported only on
ports on GE3 and GE1020 line cards. XFP transceivers are supported only
on ports on 10GE line cards.
Note: Transceivers are are hot-swappable; you can replace any transceiver
without removing the Gigabit Ethernet card. However, you must shut
down the port before performing the replacement procedure.
Stop!
Risk of data loss. You can corrupt the system if you attempt to install
transceivers (GBICs, SFP, or XFPs) that are not approved by Ericsson because
these items have not been tested with the SmartEdge router. To reduce the
risk, install only the transceivers approved by Ericsson.
To remove a transceiver of any type:
1. Shut down all activities on the port with the transceiver you want to replace.
See related documentation at https://ebusiness.ericsson.net.
2. Put on an antistatic wrist strap and attach it to an appropriate grounded
surface. Do not attach the wrist strap to a painted surface; an ESD
convenience jack is located on the front of the fan tray.
Stop!
Risk of damage to fiber-optic cables. Never stop on a cable; never twist it
when connecting it to or disconnecting it from a line card.
3. Label and disconnect any cables attached to the transceiver you want to
replace.
Stop!
Risk of ESD damage. Transceivers contain electrostatic-sensitive devices.
To reduce the risk of ESD damage, always use an ESD wrist or ankle trap
when handling any transceiver. Avoid touching its connector pins.
4. Release the latching mechanism:
38
27/153 30-CRA 119 1170/1 Uen A | 2010-04-09