Ericsson SmartEdge 600, Руководство по оборудованию

Страница: 55 / 174

Hardware Control and Troubleshooting
3 Hardware Control and Troubleshooting
The operating system command-line interface (CLI) includes commands
that display hardware configuration and status information, allow hardware
troubleshooting, and provide hardware control and recovery. You enter all
commands through the management port or the console port on the active
controller card. When the system is powered on or reloaded, the active
controller card is in slot 7.
The mode in which you enter a command is as follows:
• Enter
show
commands in any mode.
• Enter
clear
and
reload
commands in exec mode.
• Enter the
card
command and the
port
command for any type of port or
channel in global configuration mode.
• Enter the
loopback
and
shutdown
commands in the configuration mode
for the port or channel.
3.1 Hardware Status
The CLI commands listed in Table 30 display status information, such as
power, temperature, ports, and alarms for the fan tray and individual cards
and ports. Required characters and keywords are shown in bold; arguments
for which you must supply a value are shown in italics. You can enter
show
commands in any mode.
For descriptions of the output for any CLI command, see related documentation
at https://ebusiness.ericsson.net.
Table 30 CLI Commands for Hardware Status
Task or Information Needed CLI Command Comments
Status of power, temperature for all installed
units show hardware
show hardware detail
Status for all ports show port
show port detail
show port counters
show port perf-monitor
Status of a specific port, including alarms
show port detail slot / port
Status of SFP and XFP transceivers show port transceiver
49
27/153 30-CRA 119 1170/1 Uen A | 2010-04-09