Enterasys 1G58x-09, Руководство по настройке

Страница: 470 / 808

About IGMP
IGMP VLAN Registration
10-14 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
multicast VLAN to be shared in the network while subscribers remain in separate VLANs. IVR
provides the ability to continuously send multicast streams in the multicast VLAN, but to isolate the
streams from the subscriber VLANs for bandwidth and security reasons.
IVR eliminates the need to duplicate multicast traffic for clients in each VLAN. Multicast traffic
for all groups is sent around the VLAN trunk once — only on the multicast VLAN. Although the
IGMP join and leave messages are scoped to the VLAN to which the client port is assigned, these
messages dynamically register for streams of multicast traffic in the multicast VLAN. The switch
modifies the forwarding behavior to allow the traffic to be forwarded from the multicast VLAN to
the client port in a different VLAN, selectively allowing traffic to cross between two VLANs.
To use IVR, only user access ports should be configured in open mode. The switch identifies clients
that are in open mode and will remap IGMP traffic to the IGMP VLAN. It will also remap the client
source IP address to the IGMP IP address. It is possible for all the switches to use the same IGMP
mode IP address, as long as that IP address is valid for the IGMP VLAN.
If GVRP is enabled, the IGMP VLAN will be propagated dynamically through the network using
the GVRP protocol. For more information on GVRP, refer to
Section 7.3.8 .
NOTE: IVR cannot be used when routing is enabled.