Enterasys 1G58x-09, Руководство по настройке

Страница: 116 / 808

General Configuration Command Set
Configuring Enterasys and Cisco Discovery Protocols
3-68 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
3.2.6 Configuring Enterasys and Cisco Discovery Protocols
Purpose
To enable and configure the Enterasys (CDP) and Cisco discovery protocols. These protocols are
used to discover network topology. When enabled, they allow Enterasys and Cisco devices to send
periodic PDUs about themselves to neighboring devices. The Cisco Discovery Protocol is also used
to manage the Cisco module of the Convergence End Points (CEP) IP phone detection function
described in
Section 11.2.6 .
Commands
The commands needed to configure the Enterasys and Cisco discovery protocols are listed below
and described in the associated section as shown.
•
show cdp ( Section 3.2.6.1 )
•
set cdp ( Section 3.2.6.2 )
•
set cdp interval ( Section 3.2.6.3 )
•
show ciscodp ( Section 3.2.6.4 )
•
set ciscodp status ( Section 3.2.6.5 )
•
set ciscodp timer ( Section 3.2.6.6 )
•
set ciscodp holdtime ( Section 3.2.6.7 )
•
set ciscodp populatecdp ( Section 3.2.6.8 )
•
show port ciscodp info ( Section 3.2.6.9 )
•
show port ciscodp neighborinfo ( Section 3.2.6.10 )
•
set port ciscodp status ( Section 3.2.6.11 )
•
set port ciscodp trust-ext ( Section 3.2.6.12 )
•
set port ciscodp cos-ext ( Section 3.2.6.13 )
•
set port ciscodp vvid ( Section 3.2.6.14 )