Enterasys 1G58x-09, Руководство по настройке

Страница: 279 / 808

SNMP Command Set
Configuring SNMP Notification Parameters
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 5-57
Example
This example shows how to display SNMP notify filter information. In this case, the notify profile
“pilot1” in subtree 1.3.6 will receive SNMP notification messages:
5.2.7.10 set snmp notifyfilter
Use this command to create an SNMP notify filter configuration. This identifies which management
targets should and should not receive notification messages, which is useful for fine-tuning the
amount of SNMP traffic generated.
By default, all management targets are excluded from receiving notification messages; therefore,
you must create an SNMP notify filter for the management targets that should receive notification
messages. If you create an SNMP notify filter to include all OIDs, you can then create SNMP notify
filters to exclude specific OIDs. As an alternative, you can create SNMP notify filters to include
specific OIDs; in which case, the OIDs that you do not specify will be excluded automatically.
set snmp notifyfilter profile subtree oid [ mask mask ] [ included | excluded ]
[ volatile | nonvolatile ]
Syntax Description
Matrix> show snmp notifyfilter
--- SNMP notifyFilter information ---
Profile = pilot1
Subtree = 1.3.6
Filter type = included
Storage type = nonVolatile
Row status = active
profile Specifies an SNMP filter notify name.
subtree oid Specifies a MIB subtree target for the filter.
mask mask (Optional) Applies a subtree mask.
included | excluded (Optional) Specifies that subtree is included or excluded.
volatile |
nonvolatile
(Optional) Specifies a storage type.