Enterasys 1G58x-09, Руководство по настройке

Страница: 552 / 808

Logging and Network Management Command Set
Configuring Convergence End Points (CEP) Phone Detection
11-82 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable both TCP and UDP convergence end points detection for CEP
detection group 1
:
11.2.6.9 set cep detection porthigh
Use this command to set the maximum and minimum ports used for TCP or UDP convergence end
points detection. Once UDP and/or TCP phone detection has been specified using the
set cep
detection protocol command as described in Section 11.2.6.8 , the protocols will use this port range
for detection matching.
set cep detection detection-id { porthigh | portlow port }
detection-id Specifies a CEP discovery group ID. This group must be
created and enabled using the
set cep detection command
as described in Section 11.2.6.5 . Valid values are 1 -
2147483647 .
tcp | udp | both |
none
Sets the CEP IP protocol type as:
•
TCP
•
UDP
•
Both UDP and TCP
•
None
Matrix> set cep detection 1 protocol both
NOTE: This command applies only to Siemens and H.323 phone detection. Cisco
detection uses CiscoDP as its discovery method.