Enterasys 1G58x-09, Руководство по настройке

Страница: 62 / 808

Startup and General Configuration Summary
Starting and Navigating the Command Line Interface (CLI)
3-14 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
3.1.6 Starting and Navigating the Command Line Interface (CLI)
3.1.6.1 Using a Console Port Connection
Once you have connected a terminal to the local console port as described in Chapter 2 , the initial
startup screen, Figure 3-2 , will display. You can now start the Command Line Interface (CLI) by
•
Using a default user account, as described in Section 3.1.6.2 , or
•
Using an administratively-assigned user account as described in Section 3.1.6.3 .
3.1.6.2 Logging in with a Default User Account
If this is the first time your are logging in to the Matrix E1 Series device, or if the default user
accounts have not been administratively changed, proceed as follows:
1. At the Username login prompt, enter one of the following default user names:
•
ro for Read-Only access,
•
rw for Read-Write access.
•
admin for Super User access.
2. Press ENTER. The Password prompt displays.
3. Leave this string blank and press ENTER.The notice of authorization and the Matrix prompt
displays as shown in
Figure 3-3 .
NOTE: By default, the Matrix E1 Series device is configured with three user login
accounts: ro for Read-Only access; rw for Read-Write access; and admin for
super-user access to all modifiable parameters. The default password is set to a blank
string (carriage return). For information on changing these default settings, refer to
Section 3.2.1 .
NOTES: Display messages shown in Figure 3-2 about the device generating keys
pertain to Secure Shell (SSH) authentication. These lines will only display on the startup
screen the first time the device is powered on, or after NVRAM has been cleared.
Once the device has been configured for routing as described in Section 3.3 , the
message “cannot open startup.cfg file” will no longer display. The startup.cfg file stores
the running configuration for the device when operating in router mode. This file does
not affect switch mode operation.