Enterasys 1G58x-09, Руководство по настройке

Страница: 37 / 808

Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 1-1
1
Introduction
This chapter provides an overview of the tasks that may be accomplished using the Matrix E1
1G58x-09 and 1H582-xx CLI interface, an introduction to in-band and out-of-band network
management, and information on how to contact Enterasys Networks for technical support.
1.1 OVERVIEW
Enterasys Networks’ Matrix E1 CLI interface allows you to perform a variety of network
management tasks, including the following:
•
Assign IP address and subnet mask.
•
Select a default gateway.
•
Assign a login password to the device for additional security.
•
Download a new firmware image.
•
Designate which network management workstations receive SNMP traps from the device.
•
View device, interface, and RMON statistics.
•
Manage configuration files.
•
Assign ports to operate in the standard or full duplex mode.
•
Configure ports to perform load sharing using trunking and link aggregation commands.
•
Control the number of received broadcasts that are switched to the other interfaces.
•
Set flow control on a port-by-port basis.
•
Configure ports to prioritize incoming frames at Layer 2, Layer 3, and Layer 4.
Important Notice
Depending on the firmware version used in the Matrix E1 1G58x-09 or 1H582-xx device, some
features described in this document may not be supported. Refer to the Release Notes shipped
with the Matrix E1 device to determine which features are supported.