UNCONTROLLED COPY WHEN DOWNLOADED OR PRINTED
ENSTROM F-28F/280F SERIES MAINTENANCE MANUAL SUPPLEMENT 1
Rev.
1
2-4
Nov
21/08
SECTION 4
SYSTEM MAINTENANCE
NOTE
Removal or installation of equipment will change the
aircraft empty weight and empty weight c.g. These
changes will be recorded on Form F-511-5, Basic
Weight and Balance Record, as required (reference
Enstrom F-28F/280F Series Maintenance Manual).
4-1. Sandia
SAE5-35
4-1-1. Removal – Sandia SAE5-35
A. Turn the Sandia SAE5-35 and aircraft power off. Pull the ENCDR circuit
breaker out. Disable the circuit breaker by installing a cable tie or other similar device
around the circuit breaker system.
B. The Sandia SAE5-35 is installed onto a tray mounted on a back panel bracket
inside the pedestal.
C. Disconnect the electrical cables.
D. Slide the unit out of the tray.
4-1-2. Inspection/Repair – Sandia SAE5-35
A. Inspect the condition and security of the mounting bracket and electrical
interface.
B. Inspect the condition and security of electrical cables.
C. Repair procedures are not available for the Sandia SAE5-35.
4-1-3. Installation – Sandia SAE5-35
A. Install the Sandia SAE5-35 onto the tray.
B. Connect the electrical cables.
C. Remove the cable tie or other similar device from the ENCDR circuit breaker
stem and push the stem in to set the circuit breaker.
Visit www.enstromhelicopter.com for instructions to order an original manual and to register for email notification of updates.
