Endress+Hauser gammapilot FTG 671, Руководство по эксплуатации

Страница: 25 / 64

Monorack wiring Fig. 2.17 shows the terminals in the base of the Monorack II housing, the pin assignments
correspond to those in Fig. 2.12. When connecting together several Monoracks, follow
the instructions BA 090F supplied with the housing.
•
Check that the jumper switch in the base is set for a Racksyst II card.
•
Where a terminal has two pin assignments, the one printed in green applies.
•
Insert the coding pins supplied at positions 2 and 7 in the female connector at
the base of the housing.
Note!
•
The Gammapilot FTG 671 is a Racksyst II card. It cannot be installed in a Monorack
I housing. These are easily identified by the lack of the jumper switch in the base,
see above.
•
Should the card accidently be installed in the wrong Monorack housing it will neither
function nor be damaged.
BA082D19
Power
Outputs
see Fig. 2.12
d2, d4, PCM-signals
DG 57
Insert coding
pins at
Positions
2 and 7
Hole for mounting
screw
Hole for mounting
screw
z2, z4, PFM signals
(DG 17/DG 27)
Jumper switch in
position for
Racksyst II card
Fig. 2.17:
Layout of Monorack II terminal
blocks
Gammapilot FTG 671 Chapter 2: Installation
23