Endress+Hauser gammapilot FTG 671, Руководство по эксплуатации

Страница: 26 / 64

2.5 Hardware configuration
Fig. 2.18 shows the configuration elements on the Gammapilot FTG 671 plug-in card.
Caution!
•
Electrostatic discharge can degrade performance or damage electronic modules.
Touch a grounded object to rid yourself of charge before handling the modules.
DG 57 detector data An EEPROM containing the detector data (DAT) is supplied with each DG 57 detector .
This must be plugged into the socket provided for it on the FTG board prior to
commissioning.
DG 57 signal switch This hook switch must always be open for operation with DG 57 and DG 17/27 detectors.
ZA 67
…
gateway Configure the Gammapilot card for remote operation via the ZA 672 Modbus gateway,
ZA 673 PROFIBUS gateway or ZA 674 FIP gateway as follows:
•
Set a unique device address between 0 and 63 at the address switch.
- When off, each switch has the value 0.
- When on, each switch is assigned the value shown in Fig. 2.10, inset.
- In the example the address is 2 + 8 = 10.
A full description of ZA 67
…
operation is to be found in the appropriate operating manual
Commulog VU 260 Z/
VU 160 Racksyst II cards automatically switch from remote operation via a ZA 67
…
gateway to
local operation via Commulog handheld terminal when the latter is plugged into the
communications sockets on the front panel. When the terminal is unplugged, the FTG 671
switches to remote operation again.
BA082E21/22
Backplane
connector
Address = 2 + 8 = 10
Adress
switch
Front panel
DG 57 signal
switch open
EEPROM
socket for DAT
Fuse
Top view
Side view
Fig. 2.18:
Position of configuration
elements on
Gammapilot FTG 671 card
Gammapilot FTG 671 Chapter 2: Installation
24