LightPulse Fibre Channel PCI Host Adapter How to Guide
Page 12 of 14
file://G:\emuweb\WWWROOT\ts\fibre-channel\docs\howto pdf\nt_alpa.htm
3/28/99
RTTOV =
n
Values are in milliseconds from 100 to 511. Default = 256.
Represents time-out between phases of Offline to Online protocol.
ScanDown =
n
Values 0 or 1. Default = 0. 0 = Lowest AL_PA = Lowest physical
disk (ascending AL_PA order). 1 = Highest AL_PA = Lowest
Physical Disk (ascending SEL_ID order).
SliFlags =
n
Values from 0 - 2. Default = 0. Controls which driver interface to
use. 0 = automode; attempt SLI-2 first. If that fails uses SLI-1. 1 =
always use SLI-1. 2 = always use SLI-2.
SimulateDevice =
n
Values 0 or 1. Default = 0. 0 = do not create a "dummy" disk
device. 1 = create a dummy disk to force the driver to load even if
no disk devices are present at boot time.
SnsALL =
n
Values 0 or 1. Default = 1. Controls which N_Ports are queried
from the NameServer. 0 = SCSI FCP only. 1 = All N_Ports.
Topology =
n
Values 0 or 1. Default = 0. 0 = FC_AL (loop), 1 = PT-PT Fabric.
When set to 1, FLOGI, SCR/RSCN and NameServer queries are
employed.
TrafficCop =
n
Values 0 or 1. Default = 0. 1 = enable FC-AL loop master to run
unfair and break potential arbitration problems by sending frames to
itself. 0 = run fair all the time.
Perform LUN Mapping
LUN mapping performs these tasks:
l
Designates which LUNs in a storage device or loop will be recognized by the Windows
NT system
l
Restricts certain disks to the Windows NT system.
From the Windows NT desktop;
1. Click Start menu, select Programs group, and select Configuration Utility.
2. In the Adapter Controls section, check the LUN Mapping box.
