LightPulse Fibre Channel PCI Host Adapter Management Page 3 of 7
Copyright Emulex Corporation - All rights reserved - 1999
firmware will be verified, downloaded, and the adapter restarted.
Memory
The Memory button brings up the Memory Dump window. Enter the desired starting
address in the Memory Offset edit box, and the length in bytes of the memory to dump in
the Count edit box.
Click Reload to display contents in the memory dump window.
Reset Bus
The Reset Bus button will emulate a SCSI bus reset.
Network
Note
Network parameters are only valid if an IP driver or
Combo driver is installed.
The Network button brings up the Network Configuration window which allows you to set
the following parameters.
l
Networking - enable or disable networking.
l
Class - Select the class of service.
Class 2 permits frame transfers with an acknowledgment and Class 3 permits frame
transfers with out an acknowledgment.
l
MTU - enter the appropriate Maximum Transfer Unit in decimal format.
Return to top of page.
Adapter Controls
General host adapter configurations are located under Adapter Controls. Check or clear the
check box to enable or disable contols. All changes take effect after a server reboot.
Automatically Map SCSI Devices
Enable – Tells the driver to automatically map new
SCSI devices as they are discovered. If the devices
have already been mapped, either by discovery or
manually, this checkbox has no effect.
Disable – Tells the driver to disable auto mapping.
You must use the utility to manually map devices.
New devices will not be usable until the device is
mapped.
