LightPulse Fibre Channel PCI Host Adapter Management Page 4 of 5
Copyright Emulex Corporation - All rights reserved - 1999
1. Select the desired test: PCI loopback, Internal loopback, External Loopback through
the GLM, or all three.
These test options are available for BIU-2 cards: BIU2 Tx and Rx DMA, BIU2 GP
DMA, and BIU2 concurrent DMA.
To perform the external loop back test, you must connect a loopback connector.
2. Configure the SRAM test by entering the number of sequences (or concurrent
sequences) and the sequence byte length.
3. Select number of passes (default is 0x50; 0 = infinity).
4. Select action to take upon encountering errors (0 = stop (default), 1 = repeat, 2 =
ignore).
Restart Host Adapters
Select this option to reset the host adapter. When restart occurs, lp6dutil performs POST
testing on the adapter and its reloads functional firmware.
Input/Output
Select this option to
open or close input and output files
. An input file is interpreted and
executed by the lp6dutil program. The output file contains a log of all messages.
Maintenance
Use this option to update the firmware or non-volatile parameters in the Flash ROM. This
option also displays program images (load list) stored in the host adapter’s memory. You
must reboot the host adapter for the new firmware to take effect.
Show Host Adapter Info
Select this option to display this host adapter data:
BIU PCI Configuration Parameters
Host Adapter Info and Status
Adapter Revisions
Display Configuration data
Service Parameters
Status/Counters Info
Link Status
Link Attention
