Elnec DATAMAN-40PRO, Руководство пользователя

Страница: 93 / 162

PG4UW
group Addresses :
device start address (default 0)
device end address (default device size-1)
buffer start address (default 0)
Split (default none)
This option allows setting special mode of buffer when programming or reading device. Using
split options is particularly useful when using 8-bit data memory devices in 16-bit or 32-bit
applications.
Following table describes buffer to device and device to buffer data transfer
Split type
Device Buffer Address assignment
None Device[ADDR] Buffer[ADDR]
Even Device[ADDR] Buffer[2*ADDR]
Odd Device[ADDR] Buffer[1+(2*ADDR)]
1./4 Device[ADDR] Buffer[4*ADDR]
2./4 Device[ADDR] Buffer[1+(4*ADDR)]
3./4 Device[ADDR] Buffer[2+(4*ADDR)]
4./4 Device[ADDR] Buffer[3+(4*ADDR)]
Real addressing will be following: (all addresses are hexadecimal)
Split type
Device addresses Buffer addresses
None 00 01 02 03 04 05 00 01 02 03 04 05
Even 00 01 02 03 04 05 00 02 04 06 08 0A
Odd 00 01 02 03 04 05 01 03 05 07 09 0B
1./4 00 01 02 03 04 05 00 04 08 0C 10 14
2./4 00 01 02 03 04 05 01 05 09 0D 11 15
3./4 00 01 02 03 04 05 02 06 0A 0E 12 16
4./4 00 01 02 03 04 05 03 07 0B 0F 13 17
Terms explanation:
Access to device address ADDR is written as Device[ADDR].
Access to buffer address ADDR is written as Buffer[ADDR].
ADDR value can be from zero to device size (in bytes).
All addresses are byte oriented addresses.
group
Insertion test:
insertion test (default ENABLE)
If enabled, the programmer checks all pins of the programmed chip, if have proper
connection to the ZIF socket (continuity test). The programmer is able to identify the wrong
contact, misinserted chip and also (partially) backinserted chip.
Device ID check error terminates the operation (default ENABLE)
Programmer provides ID check before each selected action. It compares read ID codes from
device with ID codes defined by device manufacturer. In case of ID error, control program
behaves as follows:
- if item is set to ENABLE, selected action is finished
- if item is set to DISABLE, selected action continues. Control program just writes warning
message about ID error to LOG window.
If enabled, the programmer checks the electronic ID of the programmed chip.
Note 1
: Some old chips don't carry electronic ID.
93