Elnec DATAMAN-40PRO, Руководство пользователя

Страница: 30 / 162

Introduction
DATAMAN-48PRO2 is a super fast universal USB/LPT interfaced universal programmer built
to meet the strong demand of the small manufacturing and developer’s community for the fast
and reliable universal programmer.
DATAMAN-48PRO2C
is a cost effective version of DATAMAN-48PRO2 programmer
(without some special devices and LPT port interface). If you need program some of the
mentioned devices, please take a look at DATAMAN-48PRO2 programmer.
DATAMAN-48PRO2 / DATAMAN-48PRO2C
support all kinds of types and silicon
technologies of today and tomorrow programmable devices without family-specific module.
You have freedom to choose the optimal device for your design. Using built-in in-circuit serial
programming (
ISP ) connector, the programmer is able to program ISP capable chips in
circuit.
DATAMAN-48PRO2 / DATAMAN-48PRO2C aren’t only programmer, but also tester of
TTL/CMOS logic ICs and memories. Furthermore, it allows generating user-definable test
pattern sequences.
DATAMAN-48PRO2 / DATAMAN-48PRO2C
provide very fast programming due to high-
speed FPGA driven hardware and execution of time-critical routines inside of the
programmer. It is least fast than competitors in this category, for many chips much faster than
most competitors. As a result, when used in production this one-socket-programmer waits for
an operator, and not the other way round.
DATAMAN-48PRO2 / DATAMAN-48PRO2C interfaces with the IBM PC Pentium compatible
or higher, portable or desktop personal computers through USB (2.0/1.1) port or any standard
parallel (printer) port (except DATAMAN-48PRO2C). Programmer can utilize power of both
USB high-speed port and IEEE1284 (ECP/EPP) high-speed parallel port. Support of both
USB/LPT port connections gives you the choice to connect the DATAMAN-48PRO2
programmer to any PC, from latest notebook to older desktop without USB port.
DATAMAN-48PRO2C has only USB interface but after upgrade to DATAMAN-48PRO2, also
high-speed IEEE 1284 (ECP/EPP) printer-port (LPT) interface is available (LPT port
connection usage is disabled in software only).
DATAMAN-48PRO2 / DATAMAN-48PRO2C provides a banana jack for ESD wrist straps
connection to easy-to-implement the ESD protection control and also other banana jack for
earth wire.
DATAMAN-48PRO2 / DATAMAN-48PRO2C have a FPGA based totally reconfigurable 48
powerful TTL pindrivers, where provide H/L/pull_up/pull_down and read capability for each
pin of socket. Advanced pindrivers incorporate
high-quality high-speed circuitry to deliver
signals without overshoot or ground bounce for all supported devices. Improved pindrivers
operate down to 1.8V so you'll be ready to program the full range of today's advanced low-
voltage devices.
DATAMAN-48PRO2 / DATAMAN-48PRO2C performs device insertion test (wrong or
backward position) and contact check (poor contact pin-to-socket) before it programs each
30