Elnec DATAMAN-40PRO, Руководство пользователя

Страница: 127 / 162

PG4UW
•
PG4UW software version
•
programmer type and serial number
•
start time of executing the Job (it means time when Load project operation was
performed)
•
end time of executing the Job (time of creating the Job Report)
•
device name
•
device type
•
checksum
•
device operation options
•
serialization information
•
statistics information
Job Report is generated in following cases:
•
user command Load project is selected
•
closing or disconnecting programmer sites is selected
•
closing the PG4UW
•
device Count down counter reaches 0 (finished status)
•
manually by user, when menu "File | Job Report" is used
The Job Report is generated for recently loaded project file, only when statistics value of
Total is greater than 0.
It means, at least one device operation (program, verify,...) must be performed.
Following options are available for Job Report:
Checkbox
Enable Job Report function - when checked, the Job Report function is active
(enabled). Otherwise the Job Report function is disabled.
Checkbox
Automatically save Job Report file - when checked, the Job Report will be saved
automatically to directory specified in edit field Job Report directory and with file name
created as following:
job_report_<ordnum>_<prjname>.jrp
where
<ordnum> is decimal order of the file. If there exist any report files with the same name, then
order for new report file is incremented about order of existing files.
<prjname> is project file name of recently used project, and without the project file name
extension.
Example 1:
Let's use the project file c:\myproject.eprj and directory for Job Report set to d:\job_reports\.
There are no report files present in the Job Report directory.
The final Job Report file name will be:
d:\job_reports\job_report_000_myproject.jrp
Example 2:
Let's use the conditions from Example 1, but assume there is already one report file present.
Name of this file is d:\job_reports\job_report_000_myproject.jrp
127