Quality from Tradition; Technology of Tomorrow
mbC:\DB-pdf\BedAnl\Modulgrav\-GB-300102.doc
16
5. Step
Loosen clamping lever (1) at
diamond holder, with the other
hand, push module down until
about 10mm above clamping
device.
Retighten clamping lever (1).
Loosen clamping lever and
adjust diamond holder in the
middle of clamping device.
Retighten clamping device (2).
6. Step
Open grip jaws of clamping
device by turning black control
knob (3). Clamp the piece which
is to be engraved.
Grip jaws can be adjusted
differently according to the type
of engraving piece.
Set the diamond into the center
of the engraving piece (2) by
open and fix the clamp.dev.(1)
7 Step
Lower diamond holder with the
help of the fine adjustment
handle (1) and adjust about
5mm above engraving piece.
8.Step
Check the type range, i.e. trace
the shape of first and last letter
and middle part of the word with
tracer.
If necessary, verify and correct:
type height,
position of template and position
of clamping device.
While tracing the letters, the
lever of the mouse (1) must be
activated. While replacing the
tracer (2), let go of the mouse
lever.
1
2
1
3
1
1
2
2
