Quality from Tradition; Technology of Tomorrow
mbC:\DB-pdf\BedAnl\Modulgrav\-GB-300102.doc
4
2.
Safety Instructions / Regulations
-
The device is intended exclusively for the engraving of metal and plastic surfaces and
for surfaces of artificially manufactured material.
-
When operating the milling module, make sure that nothing gets into the operating area
of the miller (rotating parts) or severe injuries may occur. This applies specifically to hair
and fingers. The miller may not be slowed down with the fingers.
-
During milling, safety goggles must be worn to protect the eyes from facings.
3.
Before Initial Operation
-
Please check the device for possible transportation damage. Such damage cannot
always be detected by looking at the shipping box. If the device shows any damage,
please contact
Elma
to clarify claims settlements.
-
Remove all safety devices which were necessary for transportation.
-
The device may only be installed and used on a dry, level and solid surface.
