Quality from Tradition; Technology of Tomorrow
mbC:\DB-pdf\BedAnl\Modulgrav\-GB-300102.doc
23
9.
Troubleshooting
Flat Engraving / Milling Engraving:
The engraving runs at a slant if:
-
the clamping device is not positioned at right angles to the table,
-
the fixing screws of the table top have been loosened.
The engraving runs with double contours if:
-
the piece which is to be engraved has not been clamped correctly,
-
mobile parts (type height adjustment, diamond holder module, clamping device and
chisel holder) have not been locked properly after they were adjusted,
-
the ball joint has play, the lock or the cap nut is loose,
-
the permissible range for type length and expansion was exceeded.
Ring-Inside Engraving:
The engraving runs at a slant if:
-
the ring has not been clamped correctly,
-
the ring-inside module has not been pressed against its fixing screws when installed,
-
the fixing screws of the table top have been loosened (see table).
The engraving runs with double contours if:
-
the tension wire is not tensioned properly,
-
the centering pieces are not screwed in tight enough,
-
the ring is not clamped in tight enough,
-
mobile parts (type height adjustment, diamond holder module, clamping device and
chisel holder) have not been locked properly after they were adjusted,
-
the ring-inside module was not coupled properly to the diamond holder module or there
is some play,
-
the permissible range for type length and expansion was exceeded (see table)
Ring-Outside Engraving:
-
see ring-inside engraving
