Quality from Tradition; Technology of Tomorrow
mbC:\DB-pdf\BedAnl\Modulgrav\-GB-300102.doc
12
5. Step
Place ring-inside module on
table top.
Guide chisel (1) through case of
ring-inside module. At the same
time, put guide pin on the back
of the ring-inside module in its
place (2), to couple the diamond
holder module. Push module on
the designated threads in table
top and fasten with the two grip
screws (3).
6.Step
Adjust ring (1) in ring receiver
with one hand and with the other
one, turn black control knob (2)
clockwise for clamping.
Loosen clamping lever (3) of
chisel holder and push chisel to
the limit stop in the direction of
the work center.
Retighten clamping lever (3).
7. Step
Testing diamond position:
Take tracer out of its park
position and bring to half height
of engraving template (1). The
tip of the diamond is now in the
center over the inner surface of
the ring (2).
8. Step
Adjusting the distance diamond
to engraving surface:
Turn knob of chisel height fine
adjustment (1) anti-clockwise.
Best at approx. 3mm.
Furthermore, the engraving
force may be adjusted at the
chisel height fine adjustment (2)
(see table for suggestion).
9. Step
Put tracer on first letter of word
and start engraving. While
tracing the letters, the lever of
the mouse (1) must be
activated. When replacing (2)
the tracer, let go of the mouse
lever.
1
3
2
3
3
1
2
1
2
1
2
1
2
