Quality from Tradition; Technology of Tomorrow
mbC:\DB-pdf\BedAnl\Modulgrav\-GB-300102.doc
15
Flat Engraving with Clamping Device
Preparation
The clamping device (1)
1 allan key (2),
the diamond holder (3)
the center bolt (4)
are available.
No modules are clamped on the
table top.
vorhanden.
1.Step
Put tracer in park position (1).
Loosen clamping lever (2) on
diamond holder module (3) and
hold module with other hand (4)
and push it up to the limit stop.
Retighten clamping lever (1).
2. Step
Loosen clamping lever at type
height adjustment (1) and
position fork at required type
height with thumb (2). The
reference is set by the lower
end of the fork (3).
Retighten clamping lever (1).
3. Step
Fix centering pin (1) on table top
with the help of the allan key.
4. Step
Position short clamping device
(1) on centering pin (2).
If necessary, clamping devices
must be adjusted with an angle
tool.
Lock clamping device by
rotating it clockwise half a turn
at black lever (3). Close grip
jaws at clamping device by
turning black control knob (4)
(clockwise).
1
4
1
3
2
2
1
3
4
2
3
1
1
1
3
2
4
