Quality from Tradition; Technology of Tomorrow
mbC:\DB-pdf\BedAnl\Modulgrav\-GB-300102.doc
18
3. Step
Fix centering pin (1) on table top
with the help of the allan key.
4. Step
Position clamping device (1) on
the centering piece (2).
Adjust the clamping device with
an angle tool.
Lock the clamping device by
rotating the black lever (3)
clockwise half a turn. Close grip
jaws at the clamping device by
turning the black control knob (4)
(clockwise).
5.Step
Loosen clamping lever (2) and
pick up milling holder (4) in the
milling holder module (3). Adjust
miller to the center of the
clamping device. Retighten
clamping lever (2). Loosen
clamping lever at milling holder
module (1). With the other hand,
push the module down to
approximately 5 mm above
clamping device.
Retighten clamping lever (1).
6.Step
Open grip jaws of clamping
device by turning black control
knob (2). Clamp in the piece
which is to be engraved (1).
Check type range with the tracer
(3), i.e. trace the shape of first
and last letter and the middle part
of the word.
If necessary, verify and corrected:
type height, position of template,
miller position and position of the
clamping device.
1
2
3
4
3
1
2
4
1
3
2
1
