Quality from Tradition; Technology of Tomorrow
mbC:\DB-pdf\BedAnl\Modulgrav\-GB-300102.doc
17
Milling Engraving with Clamping Device
Preparation
The Miller (1)
the miller holding plate (2)
and a 3mm allan key
are available.
The flexible shaft has a wire
mounting (3), which makes it
possible to stabilize the flexible
shaft.
The miller is attached to the tube
underneath the type adjustment
6.5mm (1), the miller holding
plate (2) is fixed to the chisel
base (3).
1.Step
Put tracer (1) into park position.
Loosen clamping lever (2) at
miller holding module and hold
module with other hand (3) and
push it up to the limit stop.
Retighten clamping lever (1).
2. Step
Loosen clamping lever at type
height adjustment (1) and position
fork to the required type height (2)
with thumb (3). Retighten
clamping lever (1).
The reference height will be the
underside of the fork (2).
1
3
1
1
2
2
3
2
3
2
3
1
