45. Check Tonneau Cover is central to vehicle and the sides of Tonneau Cover do not contact the vehicle bed rail. Adjust position if
necessary by loosening the top hinge screws and re-positioning Tonneau Cover to fit centrally on vehicle. Re-tighten hinges to torque
5Nm.
See Dia #45.
Diagram #45
46. Attach the gas struts by clipping them into place as shown.
ENSURE THE NARROW END MOUNTS TO THE VEHICLE.
Connect
the wiring harness to the terminals on the driver’s side gas strut as shown.
See Dia #46. NOTE: Attach gas strut with terminals to
the driver’s side of the vehicle.
Diagram #46
TC0123b
page 20 of 28
3PC TONNEAU COVER WITH SPORTS BAR & REMOTE LOCKING
21/05/08
NEXT STEP
RE-TORQUE 5Nm
ENSURE
CLEARANCE
TO TUB
LOOSEN HINGE SCREWS
TO ADJUST TONNEAU
POSITION IF NECESSARY
1
2
2
GAS STRUT
DRIVER’S SIDE ONLY
47. Adjust jacking bolts until corner pieces are level with the main surface of the Tonneau Cover. Once in the correct position, lock the
M8 nuts into position against the bracket using a spanner. Repeat for other side of vehicle.
See Dia #47.
Diagram #47
RIGHT HAND SHOWN
CORNER
PIECE
TONNEAU
COVER
1
2
M8
NUTS
M8 HEX
HEAD BOLT
CORNER
PIECE
LARGE
END
NARROW
END
1
2
GAS STRUT
BOTTOM
GAS
STRUT
TOP
WIRING
HARNESS
