TC0123b
page 23 of 28
3PC TONNEAU COVER WITH SPORTS BAR & REMOTE LOCKING
21/05/08
55. Apply non-acetic silicon between the vehicle, rubber extrusion and corner piece at the locations shown FROM THE UNDERSIDE
OF CORNER PIECE. Repeat process for the other side of the vehicle.
See Dia #55
.
NOTE: Ensure the bead of silicon does not
protrude through the gap between the corner piece and the vehicle to become visible from above the corner piece.
Diagram #55
NOT SUPPLIED
SILICON
CORNER PIECE
RIGHT HAND SHOWN
53. Now that the lock striker bracket has been positioned correctly, centre punch and drill Ø5mm holes through the bracket and into the
side rail as shown. Apply rust inhibitor to the drilled holes and then fasten the bracket into place using pop rivets as shown. Repeat
process for the other side of the vehicle.
See Dia #53
.
Diagram #53
10mm
Ø5mm
1
2
RIGHT HAND SHOWN
CENTRE PUNCH,
DRILL Ø5mm HOLES
& APPLY RUST
INHIBITOR
LOCK STRIKER
BRACKET
RIGHT HAND SHOWN
LOCK STRIKER
BRACKET
POP RIVETS
54. Apply non-acetic silicon between the rubber extrusion and the outside of the corner piece as shown. Apply non-acetic silicon
between the rubber extrusion and the inside of the corner piece as shown. The sealant is used to close up gaps in the assembly to
prevent water entering the vehicle bed area. Repeat process for the other side of the vehicle as shown.
See Dia #54
.
Diagram #54
NOT SUPPLIED
1
RIGHT HAND SHOWN
RUBBER
EXTRUSION
2
RIGHT HAND SHOWN
CORNER
PIECE
SILICON
UNDERSIDE OF
CORNER PIECE
EXTRUSION
HEADER RAIL
SILICON