C
C-3
Troubleshooting
No tray ____
Tray ___ error
The specified tray is unavailable. For instructions, see the copier
console.
Paper jam
To print, clear ___
There is a paper jam in the specified location. Open the doors and
check the locations indicated on the copier touch panel. The
Fiery X3e will resume printing when you have cleared the paper
jam and closed the doors.
Power saving mode
Sleep mode
The copier is in power saving mode. You must wait for the copier
to warm up before you can print.
Remove paper from
___ tray
Too much paper in ___
tray
The specified tray or bin is full. You must remove paper before
continuing the job.
Replace ___
___ near/over life
limit
The specified component is nearing or past expected useful life.
Contact your service representative for a replacement.
Sort/Staple/Punch
error
Unable to staple/
punch/duplex
An error has occurred in the specified location. Printing will
proceed when the error has been resolved.
Warming Up . . .
This is a normal status message. The copier is warming up,
and will be ready for printing in a few minutes.
Warning: Image
Control
An error has been detected by the copier’s moisture sensor or one
of its drum thermistors. For details, see the copier documentation.
___ full
The specified tank or container is full. Call your service
representative. Printing will resume after the copier returns to
ready status.
___ not set
The specified component is not set properly. Refer to the copier
console or your copier documentation for instructions. Printing
will resume after the copier returns to ready status.
___ open
The specified door or copier component is open. Printing will
resume when you close the specified door or component.
Fiery X3e message
Corrective action/additional information
