Efco SPARTA 381, Инструкция для оператора

Страница: 30 / 352

26
GB
WARNING: Gasoline is an extremely
flammable fuel. Use extreme caution when
handling gasoline or fuel mix. Do not smoke
or bring any fire or flame near the fuel or the
unit.
· To reduce the risk of fire and burn injury,
handle fuel with care. It is highly flammable.
·
Mix and store fuel in a container approved for
gasoline.
· Mix fuel outdoors where there are no sparks or
flames.
·
Select bare ground, stop engine, and allow to
cool before refueling.
· Loosen fuel cap slowly to release pressure and
to keep fuel from escaping around the cap.
·
Tighten fuel cap securely after refueling. Unit
vibration can cause an improperly tightened
fuel cap to loosen or come off and spill
quantities of fuel.
·
Wipe spilled fuel from the unit. Move 3 metre
away from refueling site before starting
engine.
· Never attempt to burn off spilled fuel under
any circumstances.
·
Do not smoke while handling fuel or while
operating the unit.
· Store fuel in a cool, dry, well ventilated place.
· Never place the machine in a combustible
area such as dry leaves, straw, paper, etc.
·
Store the unit and fuel in an area where fuel
vapors cannot reach sparks or open flames
from water heaters, electric motors or
switches, furnaces, etc.
·
Never take the cap off the tank when the
engine is running.
- Place the upper hub (B2) in position and tighten
the 4 screws (D), without finally tighten yet.
- Line up the handlebar at a right angle to the
drive tube.
MOUNTING THE CONTROL HANDLES (Fig. 6)
- Loosen the screw (G, Fig.6). The nut (H) remains
in the control handle (L).
- Push the control handle (L) (throttle trigger M
must point toward the gearbox) onto the bike
handle (N) so that the holes (P) line up.
- Insert screw (G) and tighten down firmly.
WARNING: Make sure that all
components are connected properly and all
screws tightened.
PREPARING TO WORK
HARNESS (4S-T, Fig. 1)
Correct adjustment of the harness permits the
brush cutter to be properly balanced and at an
appropriate height from the ground (Fig. 10-14A).
- Put on the single or double harness.
- Hook the brush cutter to the harness using the
hook (A, Fig. 12).
- Position the hook (B, Fig. 12) to obtain the best
brush cutter balance.
- Position the buckle (C, Fig. 13-14B) to obtain
the correct brush cutter height.
WARNING! – When using wood-cutting
blades (22-60-80 teeth) a double harness with
quick-release mechanism
must be worn.
APPROVED POWER TOOL ATTACHMENTS
The following Emak attachments may be mounted
to the basic power tool:
EP 100
Pole pruner
(1)
(1) Not approved for use with bike handle units
(SPARTA 381 T - 441 T - STARK 3810 T - 4410 T)
.
5. STARTING
FUELING
OIL
2%-50 : 1
1
5
10
15
20
25
GASOLINE
l
0,02 (20)
0,10 (100)
0,20 (200)
0,30 (300)
0,40 (400)
0,50 (500)
l
A
(cm
3
)