A533-23-880 Issue C
Page 54
© Edwards Limited 2009. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
Pump display terminal menus and display formats
1. Press the Setup button to enter the Setup menu (Figures 28, 29 and 30).
2. Use the up and down buttons to change the first digit of the setup password to the correct value, then press the
ENTER button.
3. Use the up and down buttons to change the second digit of the setup password to the correct value, then press
the ENTER button.
4. Use the up and down buttons to change the third digit of the setup password to the correct value, then press the
ENTER button.
5. If you have entered the correct password, the display will then show 'SETUP MENU' on the top line and 'Inlet
Purge' on the bottom line.
6. Press the down button six times or press the up button five times; the display will then show 'SETUP MENU' on
the top line and 'Units' on the bottom line.
7. Press the ENTER button; the display will then show 'Units Select' on the top line and 'Pressure' on the bottom line
(refer to Figure 32).
8. Press the ENTER button; the display will then show 'Pressure' on the top line and the currently selected pressure
units on the bottom line.
9. Press the up or down buttons to change the units displayed to the required units, then press the ENTER button.
Pressures will now be displayed in the units you selected.
Table 15 - Menu structure
Menu
Figure
Switch on
Switch off
Normal
Status
Control
Setup
Inlet purge
Gas Ballast
Gate Valve 1
Run Til Crash
Units
Normal display
Service
Serial Numbers
Zero sensors
Gas Valve Control
Manual
View Status
Messages
Warning and alarm messages
35
36
37
38
40
41
41
42
43
44
45
46
47
49
50
51
52
55
57
58
