© Edwards Limited 2009. All rights reserved.
Page 51
Edwards and the Edwards logo are trademarks of Edwards Limited.
Pump display terminal menus and display formats
A533-23-880 Issue C
4
Pump display terminal menus and
display formats
4.1
Introduction
The menus used and the display messages shown on the Pump Display Terminal are described in the menu diagrams
in Figures 21 to 45. The following symbols and conventions are used in the menu diagrams:
These are flow lines. Arrows on the lines show the direction of flow through a menu.
This symbol is used to connect different menus and shows the starting point (or continuation point) of a menu.
This symbol is used for the ENTER and CANCEL buttons and the four menu buttons: Normal, Status, Control and Setup.
This symbol is used for the up ( ) and down ( ) buttons and for the on (
) and off (
) buttons.
This symbol is used for the two-line display on the PDT.
This symbol is a submenu box; a submenu is a series of menu steps which are used in a number of different menus or
used in different parts of one menu. Completion of the menu returns to the previous menu.
This symbol shows additional text which is not part of the menu, but which further describes the operation of the
menu.
4.2
General operation
When you first switch on the iF system, the normal display is shown: refer to Figure 24. Refer to Figure 20. You can
then press the On or Off button (1 or 10) or any of the four menu buttons (7) to enter the corresponding menu. Then,
regardless of the current menu and display status, when you press any of these buttons, you exit the current menu
and enter the corresponding new menu. Figure 21 shows this menu control logic.
<Name>
☞
