A533-23-880 Issue C
Page 114
© Edwards Limited 2009. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
service, spares and accessories
8.4
Ordering accessories
Note:
All of the accessories in Section 8.4.1 to 8.4.2 must be ordered when you order your iF system. The
accessories you have ordered will be supplied fitted to your iF system.
8.4.1
Exhaust Temperature Sensor
The Exhaust Temperature Sensor monitors the temperature in the iF exhaust outlet. When fitted, the output of the
Sensor is monitored by the iF system. If required, you can configure the iF system to generate a warning if the exhaust
temperature is too low or too high.
8.4.2
Active gauge connection kit
The Active Gauge Connection Kit allows the iF system to monitor the pressure measured by an Active Gauge fitted in
the inlet pipeline to the iF system.
The Connection Kit is suitable for use with any of the following Edwards Active Gauges:
ATC-M Active Thermocouple Gauge
ASG (1000 mbar) Active Strain Gauge
APG-MP Active Pirani Gauge
APG-L Active Pirani Gauge (Heated)
Barocel Capacitance Manometers (10 to 1000 mbar or torr).
When supplied, the Active Gauge Connection Kit is configured for use with an APG-MP Active Pirani Gauge. You will
need to fit an iF PC Interface Kit if you want to reconfigure the iF system for use with another gauge type (refer to
Section 8.5.4).
8.5
Other accessories
8.5.1
iF Communications Module
Fit a Communications Module accessory to allow your Process Tool or PC-based software to control and monitor the
operation of the iF system through a serial port or through a parallel port, with a small number of digital lines:
Serial port communications use the RS232C communications protocol.
Parallel port communications implement a sub-set of the iF Tool Interface Module communications. A single
digital control input is used to turn the pump(s) on and off, and four digital outputs provide pump(s) on,
warning and alarm status outputs.
Accessory
Item Number
Exhaust Temperature Sensor
A532-07-000
Accessory
Item Number
Active Gauge Connection Kit
D372-41-000
Accessory
Item Number
iM Serial Communications Module
D372-32-000
iM Serial and Parallel Communications Module
D372-35-000
iM Parallel Communications Module
D372-36-000
