Edwards Signaling 5532M-AQ, Руководство по установке

Страница: 2 / 26

P/N 3100346 ISSUE 3 PAGE 2
Recor Recor
Recor Recor Recording a
ding a
ding a ding a ding a V
V
V V Voice Message
oice Message
oice Message oice Message oice Message
(5540MV (5540MV (5540MV (5540MV (5540MV-485Y6) -485Y6) -485Y6) -485Y6) -485Y6)
Figure 2. Voice Module Board
Message Switch Settings
Location Start A B
1 0 Sec. ON ON
2 5 Sec. OFF ON
3 10 Sec. ON OFF
4 15 Sec. OFF OFF
(Figure 2). For programming a message longer than
five seconds, use Message Location 1.
2. Put switch C on the programming dipswitch in the
"ON" position for programming mode (Figure 2).
3. Press and hold the record button while speaking clearly
into the microphone to record your message. Release
the button when recording is complete.
Dimensions
5532M 5532MHV
A 8 7/8" 11 1/2"
(225 mm) (292 mm)
B 8 1/4" 9 3/4"
(210 mm) (248 mm)
C 13" 14 1/4"
(330 mm) (362 mm)
Figure 1. Speaker/Amplifier Dimensions
Four five-second messages (or one twenty-second message)
can be recorded on the voice module unit. Refer to Fig-
ure 2.
1. Put switches A and B on the programming dipswitch
in the proper position for the message to be recorded
WARNING WARNING
WARNING WARNING WARNING
High voltage is present when product is energized.
5. Adjust the volume as necessary. Set the main volume
using the potentiometer on the main board (Figures
13, 14 and 15) and then set the voice volume using
the potentiometer on the voice module board (Figure
2).
Installation Installation Installation Installation Installation
The Adaptatone may be mounted to any flat surface or
may be used as a freestanding unit mounted to a rigid
pipe. The Adaptatone must be installed in accordance
with the latest edition of the National Electrical Code or
other regulations applicable to the country and locality
of installation and by a trained and qualified electrician.
NOTE: The increased resistance due to long wire runs
needs to be accounted for in sizing wire.
Consult Applications Engineering for details.
For catalog numbers ending in "AQ," 24V AC power must
be transformer isolated from mains or line power.
WARNING WARNING
WARNING WARNING WARNING
High volume may cause harm to personnel in close
proximity.
4. To test the message, press and hold PLAY while in
programming mode.
NOTE: This will play only the current location.
TERMINAL
BLOCK TB1
VOICE MODULE POTENTIOMETER
FOR VOLUME ADJUSTMENT
INPUT BOARD
(SEE FIGURE 7)
VOICE MODULE
BOARD
PROCESSOR BOARD
PROGRAMMING
DIPSWITCH
PLAY
RECORD
RECORD
LED
MICROPHONE
PROGRAMMING
DIPSWITCH
(SWITCHES SHOWN
IN "OFF" (OPEN)
POSITION)
A B
PGM
DIRECTION OF
INCREASING
VOLUME