P/N 3100010 ISSUE 3
PAGE 4
WARNING
To ensure integrity of the enclosure: Ensure the cover
gasket, part number P-007549-0069, is adhered into
groove at cover perimeter before replacing the signal box
cover.
Ensure that the (4) collar gaskets, part number P-041930-
0362, are in place on each cover screw before securing the
signal box cover.
When securing cover, start screws by hand, making sure
they are threaded into tapped holes in housing bosses
before securing with a screwdriver. Torque signal box cover
screws to a minimum of 20 in-lbs. This ensures the
required tight fit.
WARNING
To ensure integrity of the Adaptatone assembly when
adjusting the speaker direction, make sure threads in the
enclosure remain fully engaged and do not turn speaker
more than 360 degrees from the original factory installed
position.
7. To adjust speaker direction, loosen large star nut
(Figure 3) and turn speaker to the approximate desired
position. Retighten nut and turn speaker slightly
clockwise until locked into place.
WARNING
Ensure that power is disconnected before cleaning inside of
unit.
8. Tightly secure the signal box cover using (4) retained
cover screws.
9. Torque signal box cover screws to a minimum of 20
in-lbs.
10. Verify operability.
Maintenance and Test
Examine the unit semi-annually for accumulation of dirt.
Clean if necessary.
The Adaptatone should be tested annually or as required
by the authority having jurisdiction to ensure continuous
service.
c. For the tone generator, select the appropriate
method of wiring to the input board from Figures
8, 9, 10, 11, 12, 16 or 17. Connect the tone
generator as shown.
d. For 5532B-AQ, 5532BDV2-AQ and 5532BHV-AQ
models, connect power source to the Speaker/
Amplifiers at TS2. Polarity must be observed for
DC models.
e. For 5532B-Y6, 5532BDV2-Y6, 5532BHV-Y6, and
5532B-N5 models, connect incoming power to wire
leads from power supply. For -Y6 models using a
DC source, black wire is positive and white is
negative and polarity must be observed. For AC
source, black is line and white is neutral.
f. For tone generator, connect incoming power to
wire leads using a butt splice or other method
listed, certified, or otherwise approved by local
authorities. Leads are both black for -AQ and -N5
models and are black for line and white for neutral
for -Y6 models.
g. Optional. Wire 24V DC battery backup to TS1-1
and TS1-2 of the Speaker/Amplifier per Figure 18
and connect 24V DC battery backup in series with
diode assembly part 2600010 (supplied) to TB1
terminals 3 and 4 on the main board of the tone
generator per Figure 7. Polarities must be
observed.
NOTE:
Terminal block TB1 can be unplugged from the
main board of the tone generator to complete
wiring.
5. Refer to Figures 14, 15 and 19 and select desired tones.
On the tone generator, set miniature programming
switches on the input board.
For input connected to IN1, set on SW1; IN2, set on
SW2; IN3, set on SW3, and IN4, set on SW4, in order
of priority desired.
WARNING
HIGH VOLTAGE is present when product is energized. High
volume may cause harm to personnel in close proximity.
6. Adjust volume level, if desired, by turning
potentiometer located on the main board (Figures 13,
14, 15 and 18) and on voice board (Figure 2).
