Edwards Signaling 5532M-AQ, Руководство по установке

Страница: 19 / 26

P/N 3100010 ISSUE 3 PAGE 2
Recording a Voice Message (5540MV-24N5
and 5540MV-24Y6)
Table 1. Programming Logic Controller (PLC) Compatibility: PLC output to meet following product input
parameters. See Figures 16 and 17
Operating voltage Max. off state Continuous on current Surge (inrush/duration)
Cat. No. (Volts*) leakage current (mA) (mA) (Amps/milliseconds)
5540M-24AQ 24V DC only 2 740 8/4
5540M-24N5 120V 60 Hz 2 360 2.82/4
5540M-24Y6 120V 60 Hz 2 320 2.82/4
5540M-120N5 120V 60 Hz 5 380 2.82/4
5540M-120Y6 120V 60 Hz 5 310 2.82/4
5540MV-24N5 120V 60 Hz 2 360 2.82/4
5540MV-24Y6 120V 60 Hz 2 320 2.82/4
Input Board Circuit 24V DC 2 6 --
Input Board Circuit 120V 60 Hz 5 13 --
Figure 2. Voice Module Board
Message Switch Settings
Location Start A B
1 0 Sec. CLOSED CLOSED
2 5 Sec. OPEN CLOSED
3 10 Sec. CLOSED OPEN
4 15 Sec. OPEN OPEN
(Figure 2). For programming a message longer than
five seconds, use Message Location 1.
2. Put switch PGM on the programming dipswitch in the
"CLOSED" position for programming mode (Figure 2).
3. Press and hold the record button while speaking clearly
into the microphone to record your message. Release
the button when recording is complete.
4. To test the message, press and hold PLAY while in
programming mode.
NOTE: This will play only the current location.
Dimensions
5532M 5532MHV
A 8 7/8" 11 1/2"
(225 mm) (292 mm)
B 8 1/4" 9 3/4"
(210 mm) (248 mm)
C 13" 14 1/4"
(330 mm) (362 mm)
Figure 1. Speaker/Amplifier Dimensions
Four five-second messages (or one twenty-second message)
can be recorded on the voice module unit. Refer to Fig-
ure 2.
1. Put switches A and B on the programming dipswitch
in the proper position for the message to be recorded
WARNING
High voltage is present when product is energized.
5. Adjust the volume as necessary. Set the main volume
using the potentiometer on the main board (Figures
13, 14 and 15) and then set the voice volume using
the potentiometer on the voice module board (Figure
2).
WARNING
High volume may cause harm to personnel in close
proximity.
TERMINAL
BLOCK TB1
VOICE MODULE POTENTIOMETER
FOR VOLUME ADJUSTMENT
INPUT BOARD
(SEE FIGURE 7)
VOICE MODULE
BOARD
PROCESSOR BOARD
PROGRAMMING
DIPSWITCH
PLAY
RECORD
RECORD
LED
MICROPHONE
PROGRAMMING
DIPSWITCH
(SWITCHES SHOWN
IN "OFF" (OPEN)
POSITION)
A B
PGM
DIRECTION OF
INCREASING
VOLUME