P/N 3100010 ISSUE 3
PAGE 5
Figure 7. Wiring to Tone Generator Terminal Blocks
(-)
(+)
Wiring is factory
installed to internal
power supply
(-)
(+)
(-)
(+)
To optional 24V DC
Battery Backup
2
4
1
3
Diode Assembly
2600010
2 4
1
3
Terminal Block
TB-1
Main
Board
+
-
Audio Output Terminals
on Tone Generator, outer
terminals (see step 3.c and 4.c)
Factory wired to speaker
in speaker/amplifiers; outer
terminals for standard volume
units, inner terminals for high
volume units
Figure 4. Wiring the 5532M Series Speaker/Amplifier
Plastic tie-wrap (provided)--
use to separate power leads
from signal and tone initiating leads
Power and
earth-ground
leads--black and
white or black for
power; yellow
striped green for
earth-ground.
Signal/Tone leads from 5540 to be
connected to Audio Coupler Board as
applicable.
Figure 5. Wiring the 5540M Series Tone Generator
Plastic tie-wrap (provided)--
use to separate power leads
from signal and tone initiating leads
Signal/Tone initiating leads to be
connected to Input Board
Audio output wiring
to be connected to Audio
Coupler Board of 5532M. Double
wire, shielded cable with
braid or drain connected to
earth-ground lead of 5540.
Up to 2500 5532M Series can be
so connected in parallel to a
single 5540M Series unit.
Power and
earth-ground
leads--black and
white or black for
power; yellow
striped green for
earth-ground.
Figure 6. Wiring the 5540MV Series Tone Generator with Voice Messaging
Plastic tie-wrap (provided)--
use to separate power leads
from signal and tone initiating leads
Signal/Tone initiating leads to be
connected to Input Board
Audio output wiring
to be connected to Audio
Coupler Board of 5532M. Double
wire, shielded cable with
braid or drain connected to
earth-ground lead of 5540.
Power and
earth-ground
leads--black and
white or black for
power; yellow
striped green for
earth-ground.
TB1