EBS Ink-Jet Systems 1500 Series, Руководство пользователя, Страница: 21 / 111

EBS
Ink Jet Systems
EBS-1500
Series Printers User's Manual
Paragraph 2 - Installing the Printer
20060920#3.1
19
c). Unscrew the plug

containing a tube and an ink filter at its tip, and remove the plug from
the bottle. Check for the ink filter at the tube tip.
d). Unscrew the plug on a new bottle and remove aluminium foil protection.
e). Put the new bottle of ink into the container. The new bottle will be accepted after the
transponder has been detected and checked (in about 10 seconds) when the printer is on
– see a message
BOTTLE ACCEPTED .
f). Put the tube with the ink filter at the tip into the bottle and screw on the plug.
g). Install the tubes onto the couplings and screw on the retaining nuts.
h). Pressurise the system and adjust the pressure to its rating value.
Connecting a new ink bottle (or replacing an ink bottle) in the ink system
with an ink pump
A detailed description of how to attach a new ink bottle (or replace an old bottle) in the system
equipped with an electromagnetic head and the ink system with a pump is given in the
document entitled
Ink System with an Ink Pump.
2.4. Removing the Head Cover
The head cover is removed to get access to valves and adjust them.
In order to remove the head cover, follow the procedure given below:
a). Turn the printer off.
b). Remove the head from the holder and remove the distance holder for packages
™
.
c). Unscrew two nuts
š
at the back of the head and remove shims.
d). While holding the head cover, press the end face of the head with your thumb until it
starts moving out freely (the places where the face should be pressed are shown in
Figure 3).
e). Push the head cover away to ensure that leading bars have moved out of the pipes
completely.
™
š
š
1
2
3
4
Fig. 2.4.1.