Eaton VoCALL 16, Инструкция по установке и эксплуатации

Страница: 70 / 116

70
InStALLAtIon And opErAtIon mAnuAL 25-13741-E January 2020 www.eaton.com
12. Communication
12.8 Holding the call at panel handset
One active call is supported on the system at any particular time. When a panel is
active on a call, any other incoming calls get added to the call list. User can decide to
cancel or put on hold the active call to respond to next call.
Call can be put on hold by pressing the ‘ Hold Call ’ key. Navigate the call list to select
next call. Press ‘ Accept Call ’ key to start the conversation.
To initiate a call from Panel while other calls are placed on hold press ‘ Back ’ key.
Dial the OS number to be called.
12.9 Listen-In call
Listen-in call is a unidirectional call with a type B Outstation. It allows panel to listen
the audio from selected type B outstation. Dial the number of the outstation and
press ‘Listen-In’ to start the call. Press ‘Cancel’ or put the handset down to
end the call.
12.10 Speak only call
Speak only call is unidirectional call with a type B Outstation. It allows panel to
transmit audio to a selected type B outstation. Dial the number of the outstation and
press ‘Speak only’ to start the call. Press ‘Cancel’ or put the handset down to
end the call.
12.11 Enable input
Calls on the system are disabled when the enable signal is activated. When the
system is in this state, no dial tone is present on any Outstations. Any attempt to
make a call from Outstations during this period is not registered ignored by panel.
System returns to normal operation once the activation is removed.
ote: n There will be no impact to any active call present on the system when the
input is activated. Panel will not acknowledge new calls.
Figure 42. Symbols for call state
DD/MM/YY
HH:MM
0102:PANEL XX
OUTSTATION 1
0101:PANEL XX
OUTSTATION 1
(2-2)
DD/MM/YY
HH:MM
0102:PANEL XX
OUTSTATION 1
0101:PANEL XX
OUTSTATION 1
(1-2)
Handset in place
Handset Off-hook
Call incoming
Call in progress
Call on hold
Call disabled