Eaton VoCALL 16, Инструкция по установке и эксплуатации

Страница: 52 / 116

52
InStALLAtIon And opErAtIon mAnuAL 25-13741-E January 2020 www.eaton.com
11. Commissioning
Enable Input
VoCALL 16 system provides facility of interfacing Non –EVCS system through Enable
Input. Input contacts should be in normally open state and will trigger on closing
the contact. System will go in non - operational mode when contacts are closed, if
it is configured to act on the input state. In this state no-calls can be made on the
system. System will continue to monitor the fault conditions.
ote: n Any call attempts made during the time input remains active will
be discarded.
Refer to local regulations for use of input.
ote: n VoCALL 16 system will act on this input only if it is activated under install ->
system settings menu. Default settings of system is disabled.
ote: n
Any active call on the network is not impacted by application the input signal.
Service date
1. Go to option – ‘
System Service date
’. [#10]
2. Enter the next service date for installed system in specified format.
Press ‘
Accept
’ .
3. For guidance on maintenance routine, refer to section 16.
ote: n It is recommended to have bi-annual check of the system by an engineer.
After every service, next service date should be updated by the engineer.
1 3 4 5 6 7 8 1 3 4 5 6 7 8 10 11 12 13 14 15 16 10 11 12 13 14 15 16 2 2
9 9
System Settings (1-2)
1
2 Panel Number
Enable Input
1
ENGINEER 2
7 Manage Users
8 Display Settings
9 System Time / Date
10 System Service Date
11 Install
12 Test
(10-12) System Service Date
Service Date - - / - - / - -
(DD/MM/YY)
0 4 / 0 4 / 2 0 New Date
Set Date