Eaton TRSM0515, Руководство по обслуживанию

Страница: 26 / 88

A. Removal and Disassembly
B. Reassembly and Installation
1. Turn out the capscrews, jar lightly to break the
1. Install the spade pin or pivot pin, nut and
gasket seal and remove the gear shift lever hous-
washer in the bore in the housing. If previously
ing from the shift bar housing.
removed, install the O-ring in the groove.
2. Secure the housing in a vise and use a large
screwdriver to twist between the spring and side of
the housing, forcing the spring from under the
three lugs. Do one coil at a time. Remove the spring.
3. Remove the washer and gear shift lever.
4. Remove the spade pin or pivot pin, nut and
washer from the bore in the housing. If necessary,
remove the O-ring from the housing.
2. Install the gear shift lever in the housing, fitting
the slot in the lever ball over the spade pin.
3. Place the tension spring washer over the lever
ball with the dished side up.
4. Seat the tension spring under the lugs in the
housing, seating one coil at a time. Use of a spring
driving tool is recommended.
5. Make sure that the three tension springs and
balls are in the shift bar housing bores and install
the gear shift lever housing and gasket on the shift
bar housing.
27
SHIFT CONTROLS