Eaton Rapid Link RAMO5, Руководство пользователя

Страница: 188 / 218

10 Parameter list
10.4 Parameter groups for RASP
184
Rapid Link 5 · RAMO5 · RASP5 10/19 MN034004EN www.eaton.com
10.4.6 Parameter group 5 (“Communication”)
Table 39: Parameter group 5 (“Communication”)
Para-
meter Designation Description Unit Min Max DS
P5-01 RS485-0 Address Unique address of the drive (keypad, OP bus) – 1 63 1
P5-02 COM Loss Timeout With an active communication link, if a valid telegram is
not received by the drive within the period set with this
parameter, the drive will react as set in P5-03. s 0 5.0 2
P5-03 Action@Communication Loss Device reaction after occuring of “Communication Loss”.
Possibilities device dependent
0: Trip
1: Ramp to stop, then trip
2: Ramp to stop only (no trip)
3: Run at preset speed 2 (P2-01) – 0 3 0
P5-04 FieldbusRampControl Fieldbus Ramp Control
0: OFF. Ramps are controlled from internal drives parame-
ters
1: ON. Ramps are controlled by the fieldbus. – 0 1 0
P5-05 NETSendPZD3 Configuration of the 3rd process data word PDO-3 from the
drive to the network master during cyclic communication.
0: Motor current in A with one decimal place, e.g. 100
≙
10.0 A
1: Output power in kW with 2 decimal places, e.g. 400
≙
4.00 kW
2: Status of the digital inputs (DI). Bit 0 = Status DI1, Bit 1
= Status DI2 …)
3: Heatsink temperature. 0 - 100
≙ 0 - 100 °C
4: User register 1. Configuration with Function Block Editor
5: User register 2. Configuration with Function Block Editor
6: P0-59 value (Selection via P5-09)
– 0 6 0
P5-06 NETSendPZD4 Configuration of the 4th process data word PDO-4 from the
drive to the network master during cyclic communication.
0: Motor current in A with one decimal place,
e.g. 100
≙ 10.0 A
1: Output power in kW with 2 decimal places,
e.g. 400
≙ 4.00 kW
2: Status of the digital inputs (DI). Bit 0 = Status DI1, Bit 1
= Status DI2 …)
3: Heatsink temperature. 0 - 100
≙ 0 - 100 °C
4: User register 1. Configuration with Function Block Editor
5: User register 2. Configuration with Function Block Editor
6: P0-59 value (Selection via P5-09)
– 0 6 1
P5-07 NETReceivePZD3 Configuration of the 3rd process data word PDI-3 from the
network master to the drive during cyclic communication.
0: reserved
1: User defined ramp times with 2 decimal places
2: User register 3. Configuration with Function Block Editor.
3: User register 4. Configuration with Function Block Editor. – 0 3 1