Eaton Network-M3, Руководство пользователя

Страница: 290 / 294

How do I log in if I forgot my password?
Troubleshooting – 290
•
•
8.5.1.3 Action #1-2
1- Check the EMPs connection and cables.
Refer to the sections Servicing the EMP>>>Installing the EMP>>>Cabling the first EMP to the device and Servicing the
EMP>>>Installing the EMP>>>Daisy chaining 3 EMPs .
2- Disconnect and reconnect the USB to RS485 cable.
3- Launch the discovery, if it is still not ok, go to Action #1-3.
8.5.1.4 Action #1-3
1- Reboot the Network module.
2- Launch the discovery.
8.5.2 Symptom #2
The EMPs orange RJ45 LEDs are not blinking.
8.5.2.1 Possible causes
C#1: the EMP address switches are all set to 0.
C#2: the EMPs are daisy chained, the Modbus address is the same on the missing EMPs.
8.5.2.2 Action #2-1
1- Change the address of the EMPs to have different address and avoid all switches to 0.
Refer to the section Servicing the EMP>>>Defining EMPs address and termination>>>Manual addressing .
2- Disconnect and reconnect the USB to RS485 cable. The address change is only taken into account after an EMP power-up.
3- Launch the discovery, if it is still not ok, go to Action #2-2.
8.5.2.3 Action #2-2
1- Reboot the Network module.
Refer to the section Contextual help>>>Maintenance>>>Services>>>Reboot .
2- Launch the discovery.
8.6 How do I log in if I forgot my password?
8.6.1 Action
Ask your administrator for password initialization.
If you are the main administrator, your password can be reset manually by following steps described in the Servicing the
Network Management Module>>>Recovering main administrator password .