9
SIT-TO-STAND TECHBENCH INSTALLATION MANUAL
Eaton.com/techbench
Sit-to-Stand Techbench
Installation Manual
C. Wiring the bench – motor cables
•
Route motor cables #1, #2, #3 & #4 as shown� Connect
each cable to Lift motor controller as shown, an
auditable click will be heard when the connection is
made�
•
Cables in work surface stiffener are to be routed as
shown using cable retainer hardware N� Cable retainer
uses existing work surface screw�
•
Excess cable for each routing should be bundled on
cable stays as shown�
•
Motor end of cable should place as shown as to not
interfere with each motor during motor assembly�
N x 2
Hardware
required
SECTION III - Assembling the corner
and linear bench
#1 motor plug
Wire stay
#3 motor plug
#2 motor plug
#2 motor plug
#2 motor plug
#4 motor
cable bundle
#4 motor plug
Cable retainer
#1 motor plug
#4 motor plug
#1 motor
cable
bundle
#3 motor
cable bundle
#3 motor
plug
