20
Sit-to-Stand Techbench
Installation Manual
SIT-TO-STAND TECHBENCH INSTALLATION MANUAL
Eaton.com/techbench
F. Ganging plate
•
Pre-assemble (2) 1/4-20 x ½" lg� hex head self-tap screws into
the left foot of one bench and (2) 1/4-20 x ½" lg� hex head self-
tap screws into the right foot of the adjacent bench� Thread
each screw only half way�
•
Move and align both benches about 8"
•
Assemble ganging plate the benches by sliding over
pre-assemble screws and then down over ganging plate
mounting slots in both benches�
•
Tighten (4) 1/4-20 x ½" lg� hex head self-tap screws�
WARNING
USE CAUTION WHEN MOVING WORK BENCHES. TWO PEOPLE
ARE REQUIRED TO AVOID INJURY.
SECTION V - Corner and linear accessories
Right hand
foot of bench
Left hand
foot of
bench
Front
mounting
hole
Mounting slot
in ganging plate
Rear mounting hole
1
/
4
-20x
1
/
2
lg. hex head
self-tap screw
1
/
4
-20x
1
/
2
lg. hex head
self-tap screw
Ganging
plate
